Machining an AR-15 lower receiver from a raw (“0%”) forging

070shaperSetup

It's difficult to see the forging in this photo, but it's attached to the angle plate on the shaper table.

It’s difficult to see the forging in this photo, but it’s attached to the angle plate on the shaper table.

Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>